3M MP7730B - Manual (Page 24)

3M ™ Personal Projector MP7630B/MP7730B 24 © 3M IPC 2001
Lo ck
DL P A T EX AS IN ST RU ME NT S P RO DU CT
Attaching the Optional Video Module to the MP7630B/MP7730B
ST AN DB Y/ ON
MP 76 30
M EN U
EX IT
1. Precisely align the two metal tabs on the bottom of the module and insert into the corresponding
slots on the back of the projector.
2. Slowly push the module to fit with the unit. Make sure that the module plugs into the AV con
nection on the projector.
3. Plug the correct cable into the corresponding jack or port in the back of the unit.
4. Select inputs by pressing the Source button, and select the appropriate source channel by
pressing the Channel Up/Down buttons.
Optional Video Module
Caution
Switching Input Signals
Pressing the Source button on the remote control or the projector will cycle between these choices
of input signals: RGB (computer), Video (composite video from a VCR), S-Video, and Tuner. The
projector will then search for the selected type of signal until it is found or switched to another type.
Scanning Channels
The MP7630B/MP7730B can receive over 100 television channels. In Tuner mode (TV and
CATV), press the Scan button on the remote control to view all available television channels. The
message “DO YOU REALLY WANT TO SCAN? YES NO” will appear onscreen. Press either the
left or right arrow buttons on the remote to reach Yes or No, then press the Menu button to enter the
selected answer. The message “TUNER IS SCANNING NOW” will display for a few seconds, and
then the scanned channels will appear for a few seconds each.
Source button
Scan button Left and Right buttons
Power down the projector before connecting the Optional Video Module or any other
device. Failure to do so may cause serious damage.