Festool ES 150-5 EQ - Manual (Page 8)

8
The sanding dust is extracted through suction
openings in the sanding base (1.13) and
trapped in the turbo-filter (1.5).
The turbo-filter has to be changed when it is
so full of dust that the extraction power
diminishes.
Inserting a turbo-filter
- Push the front cardboard section of the tur-
bo-filter with the sealing lip (1.4) onto the
extraction nozzle (1.9) of the filter holder
- Insert rear cardboard section with slot (1.6)
onto the retaining strip (1.7) of the filter hol-
der
- Push the filter holder with its opening (1.11)
as far as it will go onto the extraction nozzle
(1.12) of the machine and clamp tight by
turning rotary knob (1.10).
4.2 External extraction by an
extraction unit
In order to avoid frequent changing of the tur-
bo-filter when carrying longer sanding jobs, it
is possible to connect a Festool extractor to
the unit instead of using inbuilt extraction.
In this case, the extraction pipe (Æ 27 mm
(1.8)) of the extraction unit is connected to
the suction nozzle (1.12).
5 Choice and installation of the
grinding disks
5.1 The appliance can be fitted with
three grinding disks of different
hardness depending on the surface
to be treated.
Hard: coarse grinding on surfaces, grinding
at edges.
Soft: universal for coarse and fine
grinding, for flat and curved surfaces.
Super-soft: fine grinding on formed parts,
curves, radii. Do not use on edges!
5.2 Assembly
The grinding disks and the tool-holding fixture
on the appliance are equipped with a positive
holder (2.1).
Make sure the grinding disk is correctly
positioned before screwing it tight.
For safety reasons, only use original Festool
grinding disks!
6 Attaching sanding material
The appropriate Stickfix sanding paper and
Stickfix sanding felt can be fastened quickly
and easily onto the Stickfix sanding base.
Always use original Festool sanding materials!
The self-adhesive sanding material (1.14) is
simply pressed onto the sanding base (1.13)
and held safely in place by the Stickfix sanding
base velcro surface.
7 Operating instructions
Never overload the tool by using too much
pressure!
The best sanding results are achieved when
applying moderate pressure.
The ES 150/3 EQ gives the best surface quality
and low abrasion.
The ES 150/5 EQ provides high abrasion with
good surface quality.
The sanding performance and quality depend
mainly on the choice of the right sanding
material.
Festool offers the appropriate sanding material
for all applications (seeFestool catalogue or on
the Internet under “www.festool.com”).
We recommend the following settings on
the rotary control (1.1) for electronic
machines:
rotary control setting
- sanding work
5 - 6
- sanding with max. drive
- sanding old paint
- sanding wood and veneer prior to painting
- interim sanding of paint on surfaces
4 - 5
- sanding of thinly applied primer
- sanding of wood with sanding vlies
- sanding edges on wooden parts
- smoothing primed wooden surfaces.
3 - 4
- sanding full wooden and veneer edges
- sanding in the grooves/rebates of windows
and doors
- interim paint sanding on edges
- pre-sanding natural wood windows with
sanding vlies
- smoothing wood surfaces with sanding felt
prior to staining
- rubbing down stained surfaces with sanding
vlies
- rubbing down or removing excess lime paste
with sanding vlies
2 - 3
- interim paint sanding on stained surfaces
- cleaning natural wood window grooves with
sanding felt
1 - 2
- sanding stained edges
- sanding thermoplastic synthetics