Festool PSBC 400 EB CARVEX - Manual (Page 19)

CARVEX
19
GB
X with the machine running (Speed range 5),
push the splinterguard in on a flat plane un-
til it is flush with the front edge of the saw
table. This beds in the splinterguard.
L When it is worn, push the splinterguard ap-
prox. 3 mm further to the rear and continue
using it.
L To guarantee reliable operation of the splin-
terguard, it must seal tightly on both sides
of the saw blade. For splinter-free cuts,
therefore, a new splinterguard should also
be used after every saw blade change.
7.4 Changing saw table
X Open the change lever [1-8] .
X Removing the saw table downwards.
L Assembly is performed in reverse sequence
to removal. Ensure that the saw table is
firmly seated in the guide.
Instead of the saw table, the angle table WT-
PS 400 or adaptation table ADT-PS 400 can be
installed at the support.
Never saw without the saw table, or one
of the other tables offered in the Festool
accessories program.
7.5 Dust extraction
The extraction adapter [6-3] allows jigsaws to
be connected to a dust extractor (hose diame-
ter 27 mm).
X Insert the extraction adapter into the rear
opening of the saw table so that the hook
[6-2] engages in the [6-1] recess.
X To remove the extraction adapter, press the
hook
[6-2] .
L Due to the low power consumption of the
machine (low energy consumption), dust
extractors with an automatic switch-on
function will sometimes only start up
when the actual cut is made.
X Set the dust extractor to continuous oper-
ation for special applications (e.g. low
stroke rate, soft wood).
7.6 Adjusting the pendulum stroke
The pendulum stroke on pendulum jigsaws can be
adjusted to machine different materials with the
correct rate of advance. Select the required set-
ting using the pendulum stroke switch
[1-11] :
Position 0 = pendulum stroke off
Position 3 = maximum pendulum stroke
7.7 Stroke speed control
The number of strokes can be adjusted step-
lessly with the adjusting wheel
[1-5] between
1500 and 3800 rpm (PSBC 400 EB: 1000 -
3800 rpm). This enables you to optimise the
cutting speed to suit the respective material.
In position A, the automatic load detection is
activated: The stroke speed is reduced in idling
and is controlled to the highest value when the
blade enters the workpiece.
8 Working with the machine
When working on small or thin workpieces, al-
ways use a stable base, or the CMS module (ac-
cessory).
When working, hold the electric power tool by
the handle and guide it along the desired cut-
ting line. For precise cuts and smooth running,
use two hands to guide the electric power tool.
WARNING
Dust hazard
X Dust can be hazardous to health. Always
work with a dust extractor.
X Always read applicable national regula-
tions before extracting hazardous dust.
Recommended pendulum stroke setting
Softwood, chip board, wood fibreboard 1 - 3
Blockboard, plywood, plastic 1 - 2
Ceramics 0
Aluminium, non-ferrous metals 0 - 2
Steel, hardwood 0 - 1
Recommended stroke speed (position
of the adjusting wheel)
Hard and soft wood, plywood board,
plywood, chip board A
Hardboard 4 - A
Plastic 3 - A
Ceramic, aluminium, non-ferrous metals 3 - 5
Steel 2 - 4
CAUTION
Material with high dust generation (e.g.
plasterboard)
Damage to machine through dust pene-
tration, risk of injury
X Do not work overhead!