Festool CMS TS 55 - Manual (Page 14)

14
CMS-TS-55-R GB
Clamping the workpiece!
Secure the stop to the front of the base in
front of the saw blade!
The stop can be adjusted in the following ways:
• Adjustment parallel to the bench edge - unscrew
the rotary knob [12-8].
• Adjustment at right angles to the bench edge -
unscrew the rotary knob [12-6].
• Adjustment of the stop ruler [12-1] lengthways -
unscrew the rotary knob [12-4]. The stop ruler
can be moved to a lower position for thinner
workpieces (Fig. [12A]) or a higher position for
thicker workpieces (Fig. [12]).
• Angle adjustment using the scale [12-5] - un-
screw the rotary knob [12-3] and lift the retaining
pin [12-2]. The rotary retaining pin engages in
the most common angle positions.
 Turning the retaining pin blocks the stop.
Make sure that all rotary knobs on the stop
are tightened before starting work. The stop
should always be used in a fixed position and
not to slide the workpiece.
9 Working with the machine
Observe the following instructions:
 Adjust the top protective cover until it rests on
the workpiece and secure in this position using
the rotary knob [9-2].
 Use the fence as a longitudinal stop to guide the
workpiece.
 You can adjust the cutting width using the scales
[10-1].
 Guide the workpiece by hand. Use the push stick
[12-7] to guide the workpiece safely past the
saw blade.When not in use, place the push stick
in the store [12-9].
10 Service and maintenance
Damaged safety devices and components must be
repaired or replaced in a recognised specialist
workshop, unless otherwise indicated in the oper-
ating manual.
Maintain the machine regularly to make sure it
functions correctly:
 Use an extractor to remove dust deposits.
 Replace worn or damaged table inserts.
 On completion of your work, wind the power ca-
ble around the holders [12-9].
11 Environment
Do not throw the power tool in your household
waste! Dispose of machines, accessories and pack-
aging at an environmentally responsible recycling
centre. Observe the valid national regulations.
EU only: European Directive 2002/96/EC stipulates
that used electric power tools must be collected
separately and disposed of at an environmentally
responsible recycling centre.
Information on REACh: www.festool.com/reach
12 EU Declaration of Conformity
We declare under sole responsibility that this prod-
uct complies with the following directives and stan-
dards:
2006/42/EG, 2004/108/EG, 2011/65/EU (from
01.01.2013), EN 60745-1, EN 60745-2-5, EN 55014-
1, EN 55014-2, EN 61000-3-2, EN 61000-3-3.
Festool Group GmbH & Co. KG
Wertstr. 20, D-73240 Wendlingen, Germany
Dr. Martin Zimmer
Head of Research, Development and Technical
Documentation
10.12.2012
WARNUNG
Risk of injury, electric shock
 Always disconnect the mains plug from the
socket before performing maintenance work on
the machine!
 All maintenance and repair work which requires
the motor housing to be opened must only be
carried out by an authorised service workshop.
Retaining panel for portable
circular saws Serial no.
CMS-TS-55-R 10002996
Year of CE mark: 2011