Festool DR 20 - Manual (Page 13)

DR 20 E
13
GB
lease current of 30mA. Always use a cable ap-
proved for outdoor use.
– Wear suitable protection: such as ear protec-
tion, safety goggles, a dust mask for work which
generates dust, and protective gloves when
working with raw materials and when changing
tools.
– Check the plug and the cable regularly and
should either become damaged, in order to avoid
a hazard, have them replaced by an authorised
after-sales service workshop.
– Always guide the cable backwards away from the
machine.
– Take care when drilling into walls as there is a
danger of rupturing concealed gas/water pipes
or cutting through power cables.
– Only for AS/NZS: The tool shall always be sup-
plied via residual current device with a rated re-
sidual current of 30 mA or less.
CAUTION! Rebound!
Rotation: Switch off device immediately!
5.3 Emission levels
Levels determined in accordance with EN 60745 are
typically:
Vibration emission value a
h
(vector sum for three
directions) and uncertainty K measured in accor-
dance with EN 60745:
The specified emissions values (vibration, noise)
– are used to compare machines.
– They are also used for making preliminary esti-
mates regarding vibration and noise loads during
operation.
– They represent the primary applications of the
power tool.
Increase possible for other applications, with other
insertion tools or if not maintained adequately. Take
note of idling and downtimes of machine!
6 Operation
On/off switch [1-4]
Press = ON, release = OFF
 The speed of the machine depends on how far
the on/off switch is pressed in.
7 Settings
7.1 Changing the rotational direction[1-3]
• Switch to the left = clockwise
• Switch to the right = anticlockwise
8 Tool holder, attachments
8.1 Tool holder in the drill spindle [2]
Bits can be inserted directly into the hexagon sock-
et holder of the drill spindle.
8.2 Chuck [1-1]
The chuck [1-1] is used for clamping drill bits [5]
and screwdriver bits.
Sound pressure level L
PA
= 88 dB(A)
Noise level L
WA
= 99 dB(A)
Measuring uncertainty allow-
ance K = 3 dB
CAUTION
Operating noise
Damage to hearing
 Use ear protection!
Drilling in metall a
h
= 2,6 m/s
2
K = 1,5 m/s
2
Fastening a
h
= 2,6 m/s
2
K = 1,5 m/s
2
WARNING
Unauthorised voltage or frequency!
Risk of accidents
 Observe the specifications on the machine’s
name plate.
 Observe country-specific regulations.
WARNING
Risk of injury, electric shock
 Always pull the mains plug out of the socket be-
fore performing any type of work on the ma-
chine!
CAUTION
Risk of injury
 Clamp the tool centrally in the chuck!