Festool DR 20 - Manual (Page 14)

14
DR 20 E GB
 Prior to initial use: apply some multi-purpose
grease to the drill spindle.
Fit the chuck [3 A]
Remove the chuck [3 B]
Change the drill bit [5]
8.3 Socket spanner adapter[4]
Socket wrenches (sockets) can be attached to the
socket spanner adapter (partly as an accessory).
Fit socket spanner adapter [4 A]
Remove socket spanner adapter [4 B]
Fit socket wrench [4 C]
Remove socket wrench [4 D]
8.4 Angle attachment [6] + [7]
The angle attachment (partly as an accessory) al-
lows the user to drill and fasten at right angles to
the machine.
 Prior to initial use: apply some multi-purpose
grease to the drill spindle and the gearbox neck.
Fit the angle attachment [6 A]
Remove the angle attachment [6 B]
8.5 Auxiliary handle [1-6]
Always use the additional handle [1-6] to
guarantee a safe, non-tiring working posture.
Attaching the additional handle [8]
 Attach the additional handle [1-6] to the neck of
the gear housing until the recesses on the addi-
tional handle engage in the lug on the housing.
 Turn the wing screw [8-1] clockwise until the
additional handle [1-6] is secured in position.
 The wing screw [9-1] can be used to adjust the
length of the additional handle [1-6][9].
 The position can be adjusted in 45° increments
[10] by turning the wing screw [10-1].
Removal in reverse order.
8.6 Depth stop [1-7]
The drilling depth can be adjusted using the depth
stop [1-7].
Attaching the depth stop [11 A]
 Turn the wing screw [11-1] on the additional
handle [1-6] anticlockwise to unscrew.
 Insert the depth stop [1-7] in the additional han-
dle [1-6].
 Pull out the depth stop [1-7] until the distance
between the tip of the drill and the tip of the
depth stop corresponds to the desired drilling
depth.
 Tighten the wing screw [11-1] on the additional
handle [1-6] again.
Removal in reverse order.
9 Service and maintenance
Customer service and repair only
through manufacturer or service
workshops: Please find the nearest
address at:
www.festool.com/Service
Use only original Festool spare parts!
Order No. at:
www.festool.com/Service
Note the following information:
– Keep the ventilation slits on the machine free and
clean to ensure adequate cooling.
– Keep the contacts on the machine, charger and
battery pack clean.
10 Accessories
Always use accessories and consumable materials
approved by Festool. See Festool catalogue or
www.festool.com.
11 Environment
Do not dispose of the device in house-
hold waste! Recycle devices, accesso-
ries and packaging. Observe applica-
ble country-specific regulations.
EU only: European Directive 2002/96/
EC stipulates that used electric power tools must
be collected separately and disposed of at an envi-
ronmentally responsible recycling centre.
Information on REACh:www.festool.com/reach
12 EU Declaration of Conformity
WARNING
Risk of injury, electric shock
 Always disconnect the mains plug from the
socket before performing maintenance work on
the machine!
 All maintenance and repair work which requires
the motor housing to be opened must only be
carried out by an authorised service workshop.
Drill Serial no.
DR 20 E 768485
Year of CE mark: 2013
EKAT
1
2 3 5
4