Gembird SIS-PMS-LAN - Manual (Page 24)

24
SIS-PMS-LAN PROGRAMMABLE SURGE
PROTECTOR WITH LAN INTERFACE
All brands and logos are registered trademarks of their respective owners
On the LAN settings page (see Figure #8 above) you can set up
DHCP, IP address, Subnet mask, Gateway, DNS server and IP filter (up
to 3 IP addresses can then be enabled for remote access).
The new settings will be applied immediately after you press the
Apply button.
IP address, Subnet mask, Gateway, DNS server will be used only if
the DHCP option is disabled.
If you set DHCP option it is recommended for your own convenience
to set up your DHCP server so that it always provides the same IP
address to SIS-PMS-LAN. To do that you will need to know the MAC
address of SIS-PMS-LAN. It can be found on this page or on the bottom
sticker of the device. The MAC address is fixed and cannot be changed.
DNS server address is important to be properly set up in case you
wish to enable the NTP timer correction option (see section 4.4 below).
IP filter option is needed to prevent unauthorized access to the
server. It restricts the web server access from any computer with IP
address different from IP1, IP2 and IP3. Make sure that you input IP1,
IP2, and IP3 correctly before enabling this option.
Power Manager client port is used for connecting with the Power
Manager software, normally it is not needed to change this setting.