Edimax Technology BR-6478Gn - Manual (Page 45)

44
to connect to this router.
2.4GHz (N): Allows 802.11n wireless network clients
to connect to this router.
2.4GHz (B+G): Allows 802.11b and 802.11g wireless
network clients to connect to this router.
2.4GHz (G): Allows 802.11g wireless network clients
to connect to this router.
2.4GHz (B+G+N): Allows 802.11b, 802.11g, and
802.11n wireless clients to connect to this router
(recommended).
Channel Number Select a channel from the dropdown menu. All access
points must use the same channel (1 to 13).
MAC Address 1 to 4 Input the MAC addresses of the wireless access points
with which you wish to connect.
Wireless Module Select “Enable” to turn on the 2.4GHz wireless
signal and select “Disable” to turn it off.
Click “Apply” to save the changes, or click “Cancel” to discard the changes. After you have
clicked “Apply”, you will see the following message:
Click “Apply” to save the changes and restart the broadband router. It takes about 60
seconds for the broadband router to restart. Click “Continue” to configure other settings.
3‐4‐1‐5 AP Bridge—WDS
In “AP Bridge—WDS” mode, this broadband router acts as both a wireless communication
bridge and a wireless access point. This router can connect to up to 4 WDS‐compatible
wireless access points and allows the computers connected every AP to communicate with
each other.