Edimax Technology 3G-6200nL - Manual (Page 7)

7
Note
The WAN “idle timeout” auto-disconnect function may not work due to
abnormal activities of some network application software, computer virus
or hacker attacks from the Internet. For example, some software sends
network packets to the Internet in the background, even when you are
not using the Internet. So please turn off your computer when you are
not using it. This function also may not work with some ISP. So please
make sure this function can work properly when you use this function in
the first time, especially your ISP charge you by access time.
Back Panel
The diagram (fig1.0) below shows the broadband router’s back panel.
The router’s back panel is divided into four sections, LAN, WAN, USB,
and Reset:
Figure 1.0
1) WAN/LAN Port
The Fast Ethernet port is for you to connect with xDSL/Cable modem or
connect with computer.
The default setting is for you to connect with
computer or switch to extend network. If you would like to access
Internet via xDSL/Cable modem, you can login 3G-6200nL to enable
WAN function (to click button ).
2)Antenna
For you to connect with antenna to get stronger wireless signal.
3) USB
The USB port allow you to share internet via 3G USB modem card.
4) WPS / Reset button
You can press the button 2~4 seconds to enable WPS for wireless
security.
When you experience some problem on using this router, or you forgot