Edimax Technology EW-7722In User Manual
Page 59
52
4. Before you start to establish the wireless connection by using WPS,
you can click ‘Rescan’ button to search for WPS-enabled access points
near you again, to make sure the WPS function of your access point is
activated.
All access points with WPS function enabled will be displayed here.
Please make sure the access point you wish to connect is displayed. If
not, please click ‘Rescan’ few more times. You can also click
‘Information’ button to see the detailed information about selected
access point.
5. Start PBC pairing procedure at access point side (please refer to the
instruction given by your access point’s manufacturer), then click
‘PBC’ button in wireless configuration utility to start to establish
wireless connection by WPS. Please be patient (This may require
several seconds to one minute to complete). When you see ‘WPS
status is connected successfully’ message, means the connection
between this wireless network card and access point is successfully
established by WPS, and the information about access point you
connected to will be displayed.
6. You can click ‘Detail’ button to see detailed information of connected