Fein AStxe649_1 - Manual (Page 14)

14
en
Using the recommended clamping devices.
Clamping device 9 07 02 001 00 1
For pipes with a diameter of up to 150 mm use clamping
device 9 07 02 001 00 1.
– Position the clamping chain (14) around the work
piece and insert the hooks of fish plate (7) in the
clamping chain (14).
– Tension the chain using gripping arm (6).
– Mount the pneumatic tool onto the supporting
bolt (20) (see “Mounting the clamping device”).
The clamping head (19) can be adjusted to the sawing
cuts and can be pivoted.
Clamping device 9 07 02 004 00 6
For large pipes with a diameter of 150 mm to 325 mm
use the clamping device 9 07 02 004 00 6 and saw blades
with a length of 500 mm or 600 mm and a thickness of
2 mm. Using the chain extension, larger pipes can also be
machined with a diameter of 440 mm.
Saw-blade guide 9 06 06 002 00 9
For operations using a saw blade with a thickness of
1.6 mm and a length of 530 mm use the saw-blade guide
9 06 06 002 00 9.
– With the auxiliary handle removed, fasten the saw-
blade guide at the drill hole on the gear head of the
power tool.
Clamping device 9 07 02 003 00 8
For machining profiled sections with a width of 290 mm
and a height of 550 mm, use clamping device
9 07 02 003 00 8. The design is equivalent to that of a
parallel vise. The clamping jaws (10+11) and the clamp-
ing head (19) are adjustable.
Clamping device 9 07 02 005 00 0 (without figure)
For cutting pipes and round materials with an external
diameter of 80 mm to 400 mm, use the clamping/feeding
device 9 07 02 005 00 0 as a guide for the hacksaw. By
means of a slipping coupling, the pressing-on time of the
saw blade is limited and thus the service life is longer. For
handling, see the Instruction Manual 3 41 00 898 06 6.
Free hand rest 3 27 14 062 02 3
For sawing materials such as corrugated metal, for exam-
ple, use the free hand rest 3 27 14 062 02 3. Disconnect
the auxiliary handle and fasten the free hand rest to the
stroke mechanism and in the drill hole on the top of the
gear head.
Repair and customer service.
Blow out the interior of the power tool at
regular intervals from outside through the air
vents with dry, compressed air.
If the supply cord of this power tool is damaged it must
be replaced by a specially prepared cord available
through the FEIN customer service centre.
If required, you can change the following parts yourself:
Application tools, auxiliary handle
Warranty and liability.
The warranty for the product is valid in accordance with
the legal regulations in the country where it is marketed.
In addition, FEIN also provides a guarantee in accordance
with the FEIN manufacturer’s warranty declaration.
Only part of the accessories described or shown in this
instruction manual will be included with your power
tool.
Declaration of conformity.
FEIN declares itself solely responsible for this product
conforming with the documents and standards given on
the last page of this Instruction Manual.
Environmental protection, disposal.
Packaging, worn out power tools and accessories should
be sorted for environment-friendly recycling.
3 41 01 081 06 0.book Seite 14 Freitag, 1. August 2008 8:37 08