M-AUDIO DMAN - Manual (Page 19)

19
Windows 3.1x Driver Control Panel
After installation, various Windows 3.1x driver parameters may
be altered via the Drivers applet of the Control Panel. To open the
Drivers applet, first open the Control Panel (usually in the
Windows 3.1x Main group), then open the Drivers applet from
within the Control Panel. The DMAN actually installs and uses
two separate drivers for its digital audio and MIDI. The "DMAN
Digital Audio / Mixer Driver” handles the digital audio
recording and playback, as well as the on-board audio mixer. The
"DMAN MPU 401” controls the MIDI port (MPU401 “UART”
mode compatible). A typical Drivers dialog is pictured below.
Windows 3.1x Drivers Applet
Audio Setup for Non-PnP Computers
If your computer has no PnP capability, or PnP is disabled, you
may modify the Windows 3.1x audio driver settings through the
Drivers Applet. First you must select the driver to set up by
highlighting “DMAN Digital Audio / Mixer Driver” entry, then
press the “Setup” button. The driver setup dialog will pop up.
Windows 3.1x Driver Setup - No PnP