M-AUDIO DMAN - Manual (Page 21)

21
Windows 3.1x Driver Setup - With PnP
For PnP systems, the Base I/O address, IRQ, DMA playback and
capture channels are all determined through the PnP mechanism.
However, you may select the duplex mode from this dialog. For
more information regarding duplex modes, see the “Audio Setup
for Non-PnP Computers” section.
MIDI (MPU401 ) Setup
You may modify the Windows 3.1x MIDI driver settings through
the Drivers Applet. First you must select the driver to set up by
highlighting the “DMAN MPU 401” entry, then press the
“Setup” button. The driver setup dialog below will pop up.
Windows 3.1x MPU401 Driver Setup
You now have the option of modifying the following resource
settings:
Port - This sets the Base I/O Address of the MPU401 device.