Hama VMPL - Manual (Page 6)

ENGLISH
Step 5: Attaching the Monitor Brackets to a television with recessed threaded inserts.
WARNING: DO NOT LAY THE TELEVISION FACE DOWN ON THE GLASS, lean it up against a wall or other solid surface!
Laying the television down on the glass may cause permanent damage.
The Monitor Brackets (b,c) should be placed as vertically close to center of the television as possible before installation. If your TV has
threaded inserts that are recessed and requires either a M4 or M5 diameter bolt, thread a M4 x 30 (e) or a M5 x 30 (g) Bolt through the
appropriate Lock Washer (l,m), an M4/M5 Washer (s), the Monitor Bracket, an M4/M5 Washer, a M4/M5 Spacer (p) and into the TV as
seen in Detailed View A of Diagram 5. If you determined that your TV requires a Bolt with a M6 or M8 Diameter, thread a M6 x 35 (i)
or a M8 x 40 (k) Bolt through the appropriate Lock Washer (n,o), the Monitor Bracket, a M6/M8 Spacer (q) and into the TV as seen in
Detailed View B of Diagram 5. Proceed to tighten the Bolts firmly with a phillips screw driver.
Detailed View A Detailed View B
Diagram 5
b c
e,g i,k
l,m n,o
s
s q
p
Step 6: Attaching Monitor to Wall Plate and adding Safety Bolts
Warning: Some televisions may require 2 people to lift! Sanus is not responsible for personal injury or product damage.
First hook the Monitor Brackets (b,c) over the top of the Wall Plate (a), then let the bottom of the Monitor Brackets rotate in under the
bottom of the Wall Plate as shown in diagram 6a. Insert the Safety Bolts (v) into the threaded holes in the bottom of the Monitor Brackets.
Tighten them with the Allen Key (w) so that they sit behind the bottom tab on the Wall Plate as shown in the Detailed View of Diagram
6b. Finally loosen the knobs and you are free to adjust your new flat panel TV.
Diagram 6a Diagram 6b
Knob
b,c
v
a
Detailed View