Hama ROC1404 - Manual (Page 6)

GB
2
The NAVI LIGHT system
The THOMSON NAVILIGHT system allows you easy
access to the settings of your television (TV) including this
feature.
1. Switch on the set you want to control.
2. Press key MENU once.
3. Navigate through the setting menus with the keys up,
down , left, right ( p, q, t, u).
4. Validate with OK.
5. To leave the menus, press key EXIT once.
You can contact THOMSON by dialling:
0871 712 1312
(For Great-Britain,
all calls will be charged 0,£10 / mn)
www.thomson-europe.com
How to retrieve
a programmed code
Method D - Automatic
code search
With this method, the remote control scrolls through the
full code list by sending an IR signal to the set to be
controlled remotely. Proceed as follows:
1. Check that your equipment is on. If not, switch it on
manually.
2. Hold down the S key until the red indicator light
blinks 3 times and then remains lit (the indicator
light remains on for a few seconds to give you the
time to proceed with the following steps. The
indicator lamp flashes to signal that this time is
almost up, and then goes off).
3. Release the S key.
4. Press the PROG p or standby B B key. After a few
seconds, the remote control begins to scroll through
the whole code list included in the library (at a rate
of roughly 1 code per second). Press the PROG
p
key once again to slow down the test speed (1 code
every 3 seconds). As soon as the set changes
channels, you must press OK to save the code and
stop the remote control scrolling through the list. If
you do not react quickly enough, you can go back
to the previous code by pressing PROG
q as
many times as necessary (you can go forward by
pressing B
B, PROGp if you have gone back too
far). As soon as the set responds again, press OK
to save the code.
It may be useful to retrieve the code programmed in the
remote control.
1. Hold down the S key until the red indicator light
blinks 3 times and then remains lit.
2. Press the S key again briefly, the indicator light
blinks once.
3. Press the number keys in decreasing order (9 to 0)
until you notice that the indicator lamp blinks once.
4. The number which made the indicator lamp blink is
the first of the three figures comprising your code,
write it down. Repeat to obtain the other two codes.
5. Repeat step 3 to find out the two other numbers of
the code.
6. When the third figure is found, the indicator lamp
goes out.
Check of
the programming
Turn on the set and press, for example, 2 to change
channels.
Try other remote control keys to find out the range of
functions you can control. If you think that not all of the
keys are active, try the programming Method B or C.
When you have retrieved the code of your
set, jot it down so that you can use it
whenever needed.
After battery replacement, you’ll have to
programme the remote control again.
ROC1404 / GB - bj - XX / bei - rst / 12-2004
TV CODE
F01_GB_ROC1404 9/12/04 17:17 Page 2