Hama VMSA - Manual (Page 5)

ENGLISH
Step 1: Mounting Monitor Brackets to a television with a Flat Back
First, determine the diameter of the Bolt (n,o,p,q) your TV requires by hand threading them into the threaded insert on the back of the TV.
If you encounter any resistance stop immediately! Once you have determined the correct diameter, see the appropriate Diagram below. You
will thread the Bolt through the appropriate Lock Washer (v,w,x,y), a Washer (bb,cc), the Monitor Bracket (d) and finally into the TV. Make
sure the Monitor Brackets are vertically centered and level with each other. Repeat process until each Monitor Bracket is secured to the TV
with 2 bolts.
Note: For TVs with a curved back or any other obstruction See Step 2. After completing this step, proceed to Step 3.
M4 Diameter Bolt M6 Diameter Bolt
d d
n p
v x
bb cc
Diagram 1
M5 Diameter Bolt M8 Diameter Bolt
d d
o q
w y
bb cc
VMSAins_011206_ML.indd 5 1/16/06 5:21:55 PM