Hama Remote Control Universal 2in1 - Manual (Page 3)

4 5
g Operating Instructions
Universal Zapper Remote Control
Function buttons
1. Power: Switch your device on/off
2. LED: lit whenever a key is pressed
3. TV
4. STB (Satellitenreceiver / Set Top Box)
5. V+/V– : volume control
6. P+/ P- : Zapping control
7.
H Mute
8. AV: External TV/VIDEO sources
9. „Info“ key
10 . Return to channel 1
Direct code input
To directly input the code read from the list:
• Switch your device on.
• Select the device you like to program (TV,
STB) .
• Hold down keys Mute (7) and the Power
(1) until the red indicator lamp remains lit.
• While the indicator lamp is on.
• P+ : 1 st number
• P- : 2nd number
• V+ : 3rd number
• V- : 4th number, enter the 4-digit code
• EXAMPLE: enter code 0027, do not press
the keys PROG+ and PROG-, press VOL+
twice and VOL- seven times. The red
indicator lamp fl ashes whenever a key is
pressed.
• To save the code, press key Mute (7) . The
red indicator lamp goes off.
• Should the code entered not be on the
list; the red indicator lamp fl ashes rapidly
during 3 seconds and then goes off.
Code check: Direct the remote control
towards the TV and try to switch it over to
standby by simply pressing the key.
Automatic code retrieval
• Switch your device on.
• Select the device you like to program (TV,
STB) .
• Direct the remote control towards the TV
and try to switch it off by simply pressing
the key Power (1). Should the set not
switch off, press Power (1) as many times
as required (up to 300 times), until the set
switches off. Between two subsequent
key depressions give the red indicator
lamp enough time to extinguish and light
up again (about 1 second). Proceeding
this way will enable you to see whether
the set responds or not.
• Immediately after the TV switches over to
standby, press key Mute (7) to store the
programming. The red indicator lamp goes
off
Retrieval of the code stored in your remote
control
When you have retrieved the code of
your set, jot it down so that you can use it
whenever needed.
After battery replacement, you‘ll have to
program the remote control again.
• Switch your device on.
• Select the device you like to program (TV,
STB) .
• Hold down keys Mute (7) and the Power
(1) until the red indicator lamp remains lit.
• Press key V-.
• To visualize the
• fi rst code digit, press P+ and count the
Rash pulses of the red indicator lamp.
The digit „0“ does not generate any Rash
pulse.
• For the second code digit, press key
P- and count the Rash pulses of the red
indicator lamp.
• For the third code digit, press key V+ and
count the Rash pulses of the red indicator
lamp.
• For the fourth code digit, press key V- and
count the Rash pulses of the red indicator
lamp. The indicator lamp extinguishes
after the last Rash.
• When you have retrieved the code of
your set, jot it down so that you can use it
whenever needed.
00040092bda.indd Abs1:4-Abs1:5 00040092bda.indd Abs1:4-Abs1:5 08.10.2009 10:24:24 Uhr 08.10.2009 10:24:24 Uhr