Hama VMPR1 - Manual (Page 9)

ENGLISH
Step 5: Add Projector
Once the desired position is located and all the Adjustment Screws are tightened, the projector may be removed for service
and re-installed without losing registration by reversing the following procedure.
Loosely install the Tapered Nuts (K) with the tapered end down on the Studs of the Universal Projector Interface (A) as
shown in Diagram 5A.
NOTE: The two halves of the VMPR1 attach by lifting the and rotating the Universal Projector Interface (A) so
that the Threaded Studs with Tapered Nuts (K) rotate into the Vee Slots of the Adjustment Bracket (D) as shown
in Diagram 5A. Once the desired position is located and the Tapered Nuts are tightened, the projector may be
removed for service and re-installed without losing registration by simply rotating the projector.
Align the four Vee Slots of the Adjustment Bracket (D) with the Threaded Studs and Tapered Nuts (K) of the Universal
Projector Interface (A); then, rotate the Universal Projector Interface until it is securely locked into the Vee Slots of the
Adjustment Bracket (D).
Tighten the Tapered Nuts (K), securing the projector and Universal Projector Interface (A) to the Adjustment Bracket (D) as
shown in diagram 5B.
Diagram 5A
K
A
D
K
A
D
Vee Slot
Diagram 5B