MAXWELL MW-1917 BK - Manual (Page 9)

9
ENGLISH
9
Induction cooker
1. Body
2. Operating surface
3. Control panel
4. Digital display
5. Temperature indicators
6. Timer button
7. Temperature maintenance
button
8. Setting ◄ ► buttons
9. Temperature setting button
10. On/Off button
Attention!
For additional protection it is reasonable to install a residual current device (RCD) with nominal
operation current not exceeding 30 mA. To install RCD contact a specialist.
SAFETY MEASURES
Before using the unit, read this instruction carefully.
Keep this instruction during the whole operation period.
• Use the unit only for intended purposes, as it is stated in this manual. Mishandling the unit can
lead to its breakage and cause harm to user or damage to his/her property.
• Before switching on the unit, make sure that the mains voltage corresponds to the voltage
specified on the unit body.
• Power cord is equipped with “euro plug”; plug it into the socket with reliable grounding
contact.
• In order to avoid fire or electric shock do not use adapters for plugging the unit in.
• Use sockets with nominal load not less than 10 A, do not plug other power-consuming units
to this socket, because simultaneous connection of several units of such type to the socket
can lead to overheating or fire.
• Install the unit in places with good ventilation.
• Do not leave the operating unit unattended.
• Unplug the unit, if you do not use it or before cleaning.
• A small noise during unit operation is normal. It is caused by interaction of cookware and
induction coil. This noise is technically inevitable and depends on cookware type.
• Do not use unit near gas-stoves or heaters, do not place it on hot surfaces.
• Do not let the power cord hang from the table or come in contact with hot surfaces or sharp
edges of kitchen furniture.
• Do not twist the cord and do not wind it up round the unit body.
• When unplugging the unit do not pull the cord but hold the plug.
• Do not touch the plug with wet hands.
• Do not use the unit next to kitchen sink, do not expose it to moisture.
• In order to avoid electric shock do not immerse the power cord, power plug or unit itself in
water or any other liquids. If the unit was dropped into water, DO NOT TOUCH the unit, unplug
it immediately. To check and repair the unit, refer to the authorized service center.
• Be careful: cookware heats up strongly during operation, do not touch hot surfaces.
MW-1917.indd 9 23.05.2012 12:54:06