STIEBEL ELTRON FTM S twin 01.05.2006 - 07.04.2008 - Manual (Page 10)

10
3. Environment and re-
cycling
For guarantees please refer to the respecti-
ve terms and conditions of supply for your
country. Recycling of obselete appliances
Appliances with this label must not be
disposed off with the general waste.
They must be collected separately and
disposed off according to local regulations.
The installation, electrical connection
and fi rst operation of this appliance
should be carried out by a qualifi ed installer.
The company does not accept liability
for failure of any goods supplied which
are not installed in accordance with the
manufacturer‘s instructions.
4. Guarantree
box of the thermostat through the trunking ( is
part of the special accessory-set „FT. . set“ ).
During and after laying, the heated mats are to
be stepped on only to the extent which is ab-
solutely necessary, to avoid mechanical damage.
If necessary, special measures are to be taken
in this regard, for example wearing shoes with
rubber soles and placing and moving the requi-
site equipment (tools) on suitable supports.
2.4.3 Electrical connection
Before the electrical connection of the heated
mat(s), the insulation resistance (> 10 M
Ω),
the continuity of current, and the resist ance
value are to be measured and documented in
the rating plate.
The electrical connection of the heated floor
mat is to be carried out in accordance with
the connection plan in these installation in-
structions.
If more than one heating mat will be installed,
the PTC-resistors (cold leads) must be inter-con-
nected in a separate wiring box (
C ) because
there is a limited cross section for it on the
temperature regulator.
It is absolutely imperative to note the rated
current of the thermostat!
The maximum allowed power supply, when
parallel connecting several heating mats,
amounts to 16 A which is a connected load of
approx. 3600 W/~230V.
If the connected load is >3600 W, then, as
switching-reinforcement a further relay is to
be installed for the temperature regulator.
The protective braiding of the PTC
connectors serves to earth the
heated mats and must be connected.
2.5 First start-up
On the occasion of the first start-up, the floor
heating is to be heated up briefly several
times, since cracks in the top covering can
otherwise arise.
2.6 Handover
Explain the functions of the heated mat and
the thermostat to the user. Make him or her
aware of the safety instructions, in particular.
Hand over the operating and installation
instructions with a finally adoted floor mat plan
to the user, as well as the type label. This is
held to be a guarantee document and must
be retained.
Heated fl
oor
mat
FTM ..
S twin
T
y
pe-No
.: ..
..
..
P
ro
d
.-
N
o
.:
. . . .
Rated v
oltage:
230
V
Rated po
w
e
r:
...
W
Width of mat:
.,..
m
Length:
.,..
m
Total resistance:
...
Ohm
Rated limit temper
ature:
90 ºC
Alter
nating v
oltage sustaining capability 4000
V
Insulation resistance check
e
d
M E A SU R E D D A T A
BEFORE
laying the mat
AFTER
laying the mat
Total resistance
(Ohm)
Insulation resis-
tance (mega-
ohms)
Room:
Company: Date / Signature:
Name :
Please be
war
e back pa
g
e
!
Prod.-No
. :
Affi x the type label of the heated mat her
e!