Plantronics Savi W430 User Manual

Page 10

Advertising
background image

Plantronics Savi User Guide

10

Subscribing a master headset

The headset and USB adapter that are supplied are subscribed
to each other. However, if you wish to use a new master headset
with your existing USB adapter, the units can be subscribed to
each other by the following method:

1

Ensure your replacement headset is charged.

2

Double press the subscription button on the USB adapter. The

USB adapter will flash red and green.

3

Press the volume up button on the headset for three seconds

until the headset indicator light turns solid green.

4

When the indicator light on the USB adapter goes solid green,

the headset and the USB adapter are subscribed to one
another.

Note

If the subscription process times out after two minutes or if

the subscription process fails, the USB adapter indicator light will
become solid red for four seconds and then return to its previous
state. If this occurs, try to re-subscribe the headset again.

Conferencing in up to three additional

headsets

While on a call, you can subscribe up to three additional headsets
to your USB adapter for conferencing. As you add headsets
to the adapter, an additional headset icon will appear in the
Plantronics software screen with a number from 1 to 3 indicating
the number of additional headsets subscribed to the adapter.

Guests may conference in as described below:

1

While you are on a call, place the guest’s headset into

subscription mode by pushing the headset volume up button
for three seconds until the headset indicator light becomes
solid green.

2

Short press (less than one second) the subscription button on

the USB adapter. The USB adapter light will flash yellow and
green.

3

The USB adapter light will then turn solid yellow and you will

hear a tone in the master headset indicating a guest wishes to
join the call.

4

If you press the call control button on the master headset

within five seconds, the guest is joined to the call.

If you do not press the call control button within five seconds,

the request to join the call is rejected and the guest will hear an
error tone in their headset.

5

Guests may leave the conference call by pressing their call

control button.

When they do you will hear a single tone in the master headset

as each guest leaves the call.

To see how many headsets are subscribed to the adapter, refer
to the lower left-hand corner of the Plantronics Control Panel
software screen. The first headset is the master headset and the
number inside the next headset is the number of guest headsets
subscribed to the adapter. The examples below show 1, then 2,
then 3 guest headsets subscribed to the adapter in addition to
the master headset.

1

2

3

Switching between wideband and

narrowband autdio

The Savi W430 is supplied with narrowband audio as the default.
You can toggle between narrowband and wideband audio by
doing a short press (less than one second) followed by a long
press (more than three seconds) on the USB adapter subscription
button while it is in an idle state. The USB adapter light will flash
red for four seconds upon entering narrowband mode and flash
green for four seconds upon entering wideband mode.

Setting the range

The Savi W430 is supplied with high range set as the default.
You can change the range setting by holding in the subscription
button of the USB adapter for three seconds while it is in an idle
state. The USB adapter light will flash green for high range, yellow
for medium range and red for low range.

ending subscription

If the USB adapter is in subscription mode and you want to stop
the adapter from searching for a headset, press the subscription
button again. The subscription light will turn solid red for four
seconds and then go to its previous state.

Placing the headset in sleep mode

If you won’t be using the headset for a long period of time and
the headset will not be in the charging cradle, you can put the
headset in sleep mode by pressing the call control button for
three seconds while in an idle state. To exit sleep mode, press the
headset call control button again for three seconds.

Advertising