Candy CVM6629PW - Manual (Page 12)

0
A
11 GB
OT-2000-LED-SD OVEN TIMER USER’s MANUAL
In the example above, cooking immediately started after giving in the
cooking period. By pressing the button, you can see the ready time,
in the time when the food will be ready to serve, and if you want, you can
also change it. In the example below, the ready time will be shifted to
21:30.
1)Displayed is the ready time
18:30 + 2:15=20:45 2)Set it to the desired time by
using + or - buttons
3)In a few seconds, screen switches to clock mode.
We now have programmed our oven to get the food ready at 21:30.
Since the cooking time was preprogrammed as 2 hours and 15 minutes,
your oven will start cooking at 19:15, so that the food is ready at 21:30.
Screen just when
cooking starts
Screen just when
cooking ends
1)Switch OFF the oven 2)Reset the timer
When automatic cooking is completed, a buzzer alarm is heared and
will sound, if not stopped, for 7 minutes.
Note: Your oven will be in operative until you reset
In the example shown, cooking time has been programmed first, the
ready time was calculated automatically and was edited by us. It is also
possible first to program the ready time. In that case, the cooking time
will be calculated automatically and should be editted thereafter.
IN CASE OF MAINS POWER LOSS
Mains power losses excluding short time (1 minute approx.) periods,
will bring your oven into OFF mode. The clock will apperar as a flashing
0:00 together with the ‘A’ symbol. Any cooking program in progress will
also be cancelled. Enter the manual mode and adjust the clock using +
or – buttons.
Note: If you will not use your oven right now, be sure that it is in OFF
position.
ADJUSTING THE BUZZER TONE:
You may adjust the buzzer tone of the timer in the following way:
1)Pressing and holding the “ – ” button, you can hear the current buzzer
tone. Releasing and pressing again will switch to the next tone (3
different tones available).
2)The buzzer tone will be set to the last adjusted tone.
Note: As factory setting, the buzzer volume is set to the high tone. In
case of a long power loss, the set buzzer tone will be this one.
A
A
A A