Candy CVM6629PW - Manual (Page 8)

Ignition of the Burners
Cooktop Gas Burners
The burner must be ignited before a pan is placed over it.
For models with automatic ignition, the 'spark' button must be
pressed.
Press the knob controlling the burner you want to ignite and then
turn it left to the big flame symbol. Press the ignition button. On
models with ignition-thru knobs, press and turn the knob
controlling the burner you want to ignite as far as the star symbol;
the electrode will be automatically activated. All the electrodes will
be activated automatically and the burner to which gas is supplied
(that relative to the knob pressed) will ignite.
Oven Gas Burners
The button must not be kept pressed down for more than 15 sec. If
the burner has not ignited after 15 sec. release the button and
open the compartment door and/or wait at least 1min. before
attempting again. For other models the gas is ignited by means of
the control knobs.
Make sure that the gas is actually burning after this
step! If there is no flame, repeat the procedure
After ignition, adjust the flame to the size required.
Manual ignition (if the electricity supply is not available)
Hold a flame (a match or a lit taper or a hand-operated gas lighter),
near the burner.
WARNING! to wait 1 minute between two ignition tentative.
Press and turn the knob of the burner you want to ignite as far as
the large flame symbol. If the burner does not catch fire at the first
attempt, try again pressing the knob a little longer. When the
burner is lit, adjust the flame to the required level.
If the burner does not light after several attempts, check the
correct position of the burner and its cap.
Turn the knob clockwise to the “O” position in order to close the
gas flow. If the burner accidentally stops burning, wait at least one
minute before attempting to relight it.
Some cookers have a flame safety device (see the picture above,
safety device F). If the flame goes out, the gas supply is
automatically cut off.
Minimum and maximum diameters of the cooking pan bases :
Burner
Large Burner
Mid - size Burner
Small - size Burner
Min. Diameter [mm]
Ø 240 mm
Ø 180 mm
Ø 120 mm
Max. Diameter [mm]
Ø 280 mm
Ø 240 mm
Ø 180 mm
A
B
C
D
E
F
TECHNICAL DATA
USE OF GAS COOKTOP BURNERS
The knobs which control the burners are positioned on the control
panel.
Off Position
When the knob is turned so that the 'dot'
symbol faces towards the panel, it is in
the Off position and the gas valve is
closed and the flame will go out.
Maximum Gas Flow
Press the burner knob and turn it to the
left till the 'dot' symbol faces towards the
large flame symbol.
The flame is on full at this position.
In this position, the gas valve is
completely open.
Minimum Gas Flow
The flame can be decreased by turning
the knob so that the 'dot' symbol faces
towards the small flame symbol. The
valve will be partially open and the
burner will then be on low.
A - Burner Lid
B - Burner
C - Electrode
D - Injector ( Jet )
E - Burner body
F - Safety device
07 GB
LPG (g/h) NG (g/h)
GAS CONSUMPTION TOTAL ELECTRIC POWER
TOTAL GAS
POWER
FEATURES
684
393
684
-/-
269
516
895
514
895
-/-
352
676
15 W
3.0 kW
1.5 kW
7.0 kW
4.5 kW
2.0 kW
9.4 kW
5.4 kW
9.4 kW
-/-
3.7 kW
7.1 kW
4 Gas burners with flame failur device, Gas oven with flame failur device
3 Gas burners with flame failur device and 1 Electrical Heater,
Electrical Oven
4 Gas burners with flame failur device, Gas oven with flame failur device
and Electrical Grill
4 Electrical Heater and Electrical Oven
2 Gas burners with flame failur device and 2 Electrical Heater,
Electrical Oven
4 Gas burners and Electrical Oven
Rating plate (located at the rear of the cooker)
15 W
2.8 kW
1.0 kW
6.8 kW
4.3 kW
1.8 kW
60 x 60 50 x 60