Acclaim Lighting ART IO - Manual (Page 6)

Network
During programming a network connection is required between the device and computer. Connect the
Ethernet port on the device to the Ethernet port on your computer by using a RJ-45 cable. Alternatively,
you can connect the device and the computer via a network switch. The Art SSC's Ethernet port is auto-
sensing so it does not matter whether you use a cross or straight cable.
The factory default IP address is 192.168.1.10 with the sub-net mask set to 255.255.255.0. Make sure your
computer is in a valid address range, e.g. set your computer to IP 192.168.1.9 with a sub-net mask of
255.255.255.0.
5