VALERA X-STYLE - Manual (Page 3)

5
• Only connect this unit to alternating current and check that the mains supply voltage corresponds to that
indicated on the unit.
• Never immerse this unit in water or other liquids.
• Do not put this unit down where it could fall into water or other liquids.
• Do not try to pull any electrical appliance out when it has fallen into water - disconnect the plug from
the power socket immediately.
• Make sure the unit is perfectly dry before using it.
• Do not put the appliance on heat sensitive surfaces during use.
• After use always switch the unit off and remove the plug from the power supply socket. Do not pull on
the wire to remove the plug from the power supply socket. Do not pull the plug out of the power supply
socket when your hands are wet.
• Always allow the unit to cool before putting it away and never wrap the cord around the unit.
• Check that the cord has not been damaged from time to time.
• Prevent the cord from coming into contact with the metal parts while these are still hot.
• Use the unit on dry hair.
• Do not use this unit on wigs that have synthetic hair.
• Do not use your unit if it is not working properly. Do not try to repair this electrical unit yourself, rather
contact an authorized technician.
• The elements used to pack the unit (plastic bags, cardboard box, etc.) must be kept out of reach of
children as they are a potential danger to them.
• This unit must only be used for the purposes for which it is expressly intended. Any other use is to be
considered improper and therefore dangerous. The manufacturer accepts no responsibility for damage
caused by improper or erroneous use.
• Do not use hair spray while the unit is running.
• Keep the plates clean and free of dust, hair spray, styling gel, etc.
• To avoid dangerous overheating, it is advisable to unwind the entire length of the cord.
OPERATING INSTRUCTIONS
Parts - Fig. 1
1. Handle
2. On/Off indicator
3. ON/OFF switch
4. Accessory release buttons
5. Plates opening lock/release
Turning the appliance on and off
To turn the appliance on, just plug it into the outlet and put the switch (fig. 1, ref. 3) on “I”. To turn it off,
put the switch (fig.1, ref.3) on “0” and unplug it.
The appliance has to pre-heat several minutes before use.
Plates opening lock/release - Fig. 2
Changing the accessory - Fig. 3 - 4
Only change the accessory with the appliance switched off and disconnected from the electrical power
supply. When changing accessories, only touch the plastic parts of the appliance of the accessory. Metal
parts may still be hot!
1. Press the accessory release button (4) and remove the accessory from the grip (1).
2. Fit the new accessory and push it firmly into the grip (1) until it clicks into place.
Important: never leave the appliance unattended when on.
Always put the appliance on the pedestal (9) when using the Irons / Plate
OPERATING TIPS
• This appliance has been designed to curl your hair, leaving it full of shine.
• Hair that has just been washed and dried can be styled better.
• The first few times you use this unit it is advisable to practice on small areas of your hair.
• The effect obtained depends on how thick and how long your hair is as well as curling time. Start by using
a curling time of 10-20 seconds.
• To make the appliance easier to use, hold the end of the accessory with your free hand.
• Use the various accessories supplied with the appliance as instructed below. If necessary, repeat the
various steps until you achieve the required effect.
• Let your hair cool completely before combing or brushing it.
• Evenly apply the hairspray over your hair to extend hold.
1. Crimper with FIat Plate
Your hair must be completely dry before using the straightener attachment. Take a section of hair and
starting from the scalp, glide the straightening plates slowly and evenly down the section of hair to smooth
and straighten. Hold the plates firmly together to ensure best results. For thicker, hard to manage hair keep
the plates held together slightly longer. Tip: When you have finished styling run a small amount of finishing
product through the hair, fattening the hair from the top and moving downwards.
2. Crimper with Wave Plate
As with the straightener, ensure that your hair is completely dry before using the crimper. Take the section
of hair and starting at the roots, hold the plates over each section for a few seconds. For a continuous
6. Straightening plates
7. Irons / plate
8. Small wave plates
9. Irons / plate pedestal
00060549 int giu2013 11/06/2013 9.06 Pagina 5