VALERA CONTOUR X CERAMIC - Manual (Page 3)

7
• Do not leave the appliance on charge in wet places and do not recharge the
appliance when it is wet.
• The appliance comes equipped with a NiMH battery. To help protect the envi-
ronment, the batteries should not be included with ordinary domestic waste,
but should be taken to a special collection point instead.
• When using the head for trimming nasal and ear hair, do not push the unit hard
into the nose or ears. Only the metal tip of the head should be inserted deli-
cately into the nose and ear cavities (1)
• Have the battery removed by qualified technical personnel or by the treatment
and recycling centre
• Do not expose the battery to liquid, moisture or high humidity
• Keep the battery away from magnetic fields, sources of heat and naked flames.
• Risk of scratches or cuts. If there is any damage to a comb, set of blades or
the nose and ear hair trimmer, do not use them: replace them immediately,
since they could cause injury to the skin, nose or ears.
• Take care not to scratch skin if using the appliance with a set of blades without
comb attachment.
USE
COMPONENTS
1
Shaver
2 Shaver head with ceramic
blades
3 0-1 switch
4 Unit charge indicator: off if the
unit is not on the base, red
during charging, green when
fully charged
5 Base/unit connections
for charging
6 Base
7 Base socket for charger
SWITCHING ON AND SWITCHING OFF
To switch on the appliance turn the switch (fig. 1 - ref. 3) on position 1. To switch
it off move the switch back to position 0.
RECHARGING THE BATTERY
Note: The unit charge indicator (fig.1 ref. 4) works on a timer which switches the
red light on for 12 hours, after which it turns green. Therefore, in the event of a
power failure during charging, the timer is zeroed. Bear this in mind when charging
the appliance.
• Before using the appliance for the first time, charge the battery for 12 hours. For
subsequent charges, allow the appliance to charge for at least 8 hours.
• In order to optimise the lifetime of the battery, never charge the appliance for
more than 24 hours.
• Discharge the battery completely every few months, then recharge it again. This
optimises the lifetime of the battery.
• Switch the appliance off using the switch (fig.1 - ref.3).
The battery can only be charged with the appliance switched off.
• Connect the transformer to the base (fig.1 - ref.6) by plugging it into the base
socket (fig.1 - ref.7) and sit the unit on the base.
• Plug the transformer into the mains.
• During charging the led (fig.1 - ref.4) lights up to indicate charging in progress.
• Only recharge the battery when you note a clear reduction in appliance power.
• When the battery is fully charged, the appliance can be used for 30 minutes
without connection to the mains.
ADJUSTABLE COMB ATTACHMENT
The comb attachment can be adjusted (fig.1 ref.16) to 5 different positions (fig.2)
for various cutting lengths.
The various positions (2 mm, 4 mm, 6 mm, 8 mm and 10 mm) are shown on the
comb setting indicator (fig.1 ref.17).
8 5-position adjustable
combattachment
9 Charger
10 Moustache comb
11 Nose and ear head
12 Finishing head for edges
13 Shaver head
14 Brush for cleaning
15 Lubricating oil
16 5-position comb adjustment
17 Comb setting indicator
00060458 interno marzo2013:00060458 interno 20/03/2013 11.42 Pagin