Sony SLV-SE100K - Manual (Page 12)

12
Tuning your TV to the VCR
To check to see if the TV tuning is correct
Set the TV to the video channel and press PROGRAM +/– on the VCR. If the TV
screen changes to a different programme each time you press PROGRAM +/–, the
TV tuning is correct.
To obtain a clear picture from the VCR
If the screen does not appear clearly in step 6 above, go to step 7 to finish this
procedure once. Then start again from step 2. After pressing RF CHANNEL in step
2, press PROGRAM +/– while the RF channel is displayed, so that another RF
channel appears. Then tune the TV to the new RF channel so that a clear picture
appears.
Note
• If you set the wrong TV system, you may have no sound or sound may be distorted.
5 Press PROGRAM +/– (repeatedly) to select the appropriate TV system for
your area. Select “G” for the B/G TV system, or “K” for the D/K TV
system.
6 Tune the TV to the same channel shown in
the VCR display window so that the
picture on the right appears clearly on the
TV screen.
Refer to your TV manual for TV tuning
instructions.
If you select the wrong TV system in step
5, the picture on the right may not appear.
Select the appropriate TV system and tune
the TV again.
If the picture does not appear clearly, see “To obtain a clear picture from the
VCR”
below.
7 Press RF CHANNEL.
You have now tuned your TV to the VCR. Whenever you want to play a
tape, set the TV to the video channel.
PROGRA
TRACING
SON VIO CASSTT RCORR
AUTO ST UP
R CANNL