Sony SLV-SE100K - Manual (Page 35)

35
Playing a tape
B
a
si
c
Op
er
a
tio
ns
Notes
• The counter resets to “0:00:00” whenever a tape is reinserted.
• The counter stops counting when it comes to a portion with no recording.
• The time counter does not appear on the TV screen when using an NTSC-recorded tape.
• Depending on your TV, the following may occur while playing an NTSC-recorded tape:
– The picture becomes black and white.
– The picture shakes.
– No picture appears on the TV screen.
– Black streaks appear horizontally on the TV screen.
– The colour density increases or decreases.
• Tapes recoreded in the LP and EP mode cannot be played back on this VCR.* 1
• The picture’s colour may be affected when playing a MESECAM-recorded tape in the LP
mode.* 2
• While setting the menu on the TV screen, buttons for playback on the remote commander do
not function.
* 1 SLV-SE100K/SX100K only
* 2 SLV-SE400K/SE450K only
Starting playback automatically with one button (One
Touch Play)
(SLV-SE450K only)
If you use the SMARTLINK connection, you can turn on the VCR and the TV, set the
TV to the video channel, and start playback automatically with one button.
Tip
• When there already is a tape in the VCR, the VCR and the TV turn on, the TV is set to the
video channel, and playback starts automatically in one sequence when you press
H PLAY.
Note
• When you use the One Touch Play function, leave the TV on or in the standby mode.
1 Insert a tape.
The VCR automatically turns on.
If you insert a tape with its safety tab removed, the TV turns on and switches to
the video channel. Playback starts automatically.
2 Press
H PLAY.
The TV turns on and switches to the video channel automatically. Playback
starts.