Vitek VT-1656 - Manual (Page 13)

Normal operation
The microwave oven causes
Static interference in television and radio signals may occur while the oven is
static in television and radio operating. Similar static is caused by the operation of small electrical appliances like
signals. mixers, vacuum cleaners and hair dryers. This is a normal occurrence.
The backlight is very dim If the microwave is set to a low power level, then the backlight may be dim.
This is a normal occurrence.
Steam is collecting During the cooking process, steam may come from the food you are cooking.
on the door, hot air is venting Most of the steam will exit through the ventilation openings, but some may end up
from the ventilation openings. on the inside of the door. This is a normal occurrence.
The microwave oven was Turning on the microwave oven for a short period of time while empty will not result
turned on while empty in malfunction.Always make sure that there is something in the microwave before
turning it on.
Technical Characteristics
Power requirements: 220 230 V ~50 Hz
Power usage in microwave mode: 1450 Wt
Nominal output power in microwave mode: 900 Wt
Operating frequency: 2450 MHz
Power usage in grill mode: 2500 Wt
Input power in convection mode: 3000 Wt
External dimensions: 520mm (H)x495mm (W)x355mm (D)
Oven volume: 28 l
Glass tray: 315mm
Weight: approx 20kg
The manufacturer reserves the right to make changes to the operational characteristics without prior notification.
Service life 5 years
Guarantee
Details regarding guarantee conditions can be obtained from the dealer from whom the appliance was purchased.
The bill of sale or receipt must be produced when making any claim under the terms of this guarantee.
This product conforms to the EMC Requirements as laid down by the Council Directive 89/336/EEC and to
the Low Voltage Regulation (23/73 EEC)
ENGLISH
13
Description of malfunction
The oven will not turn on
The oven does not heat
During operation, the glass
tray makes strange noises
Method of elimination
Remove the plug from the outlet. After 10
seconds, insert the plug back into the out
let.
Try plugging another electrical device into
the same outlet to verify the problem
Close the door firmly
Remove the glass tray and rolling ring.
Clean the rolling ring and the cooking
chamber floor.
Possible reason
The power plug is not securely con
nected to the electrical outlet.
Problem with electrical outlet
The door is not firmly closed
The rolling ring or oven floor is dirty
Eliminating malfunctions
1656.qxd 27.06.05 14:58 Page 13