Vitek VT-1656 - Manual (Page 7)

• During the cooking process, always use the glass
tray, rolling ring and tray base.
• Food and cooking dishes must always be placed
only on the glass tray.
• The glass tray may rotate clockwise or counter
clockwise. This is normal.
• Replace the tray immediately if it becomes cracked
or chipped.
Installation
• Before connecting the microwave oven, make sure
that the operating voltage and power usage matches
the parameters of your electrical system. Connect
the microwave oven to a grounded electrical outlet.
• Install the oven on a flat, stable surface. Choose a
location that will not be accessible to small children.
• Install the oven so that the distance between the wall
and the back of the oven is no less than 7 8 cm and
the free space above the microwave is no less than
30 cm.
• Do not remove the legs from the bottom of the
microwave oven.
• Do not block the ventilation openings on the
microwave oven's housing.
• The microwave oven should be installed away from
televisions and radios in order to prevent static inter
ference of radio and television signals.
WARNING: Do not install the microwave oven on heat
ing surfaces (kitchen stoves) or other sources of heat
waves.
If the microwave oven malfunctions due to user error,
the warranty for free service and repair is voided.
While operating, the top surface of the microwave oven
and heat up significantly; avoid touching hot surfaces of
the oven with bare skin in order to prevent burns.
Instructions for using the microwave
oven
1. Setting the time
Upon connecting the microwave oven to power, it will
beep and the display will show "0:00".
You can set the time from 0:00 23:59;
For example: To set the time as 12:12.
•
Press the (4) "CLOCK/PRE SET" button; the dis
play will show the current time format of 24Н; press
the button again to choose a 12H format.
• Press the number buttons "1", "2", "1", "2".
• Press the (4) "CLOCK/PRE SET" button to finish
setting the time. The display will show the set time of
12:12 and the separation dots (9) will blink.
Note:
•
If the time is not set, the current time will not be
shown on the display.
• If the time is set incorrectly, press the (6)
"STOP/CLEAR" button to clear the setting and
repeat steps 1, 2, and 3.
2. Cooking in the microwave oven
Choose the power level and set the cooking time. Press
the (2) "MICROWAVE" button several times to set the
desired power level for the oven.
Number of key presses Display reading Oven power level
1 Р100 100%
2 Р80 80%
3 Р50 50%
4 Р30 30%
5 Р10 10%
For example: To start the oven for 10 minutes at an 80%
power level, complete the following steps:
•
Open the oven door, place the food into the cooking
chamber, and then close the door.
• Press the (2) "MICROWAVE" button; the indication
"Р100" and symbol (1) will appear on the display.
• Press the (4) "MICROWAVE" button again; the indi
cation "Р80" will appear on the display.
• Press the number buttons "1", "0", "0", "0"; the
time "10:00" minutes will appear on the display.
• Press the (11) "START/+30SEC./CONFIRM" but
ton to begin cooking; the display will show the
remaining cooking time as it counts down and the
symbol (1) will blink.
When the cooking process has finished, the oven will
turn off and beep five times.
ENGLISH
7
1656.qxd 27.06.05 14:58 Page 7