Activeforever PresSsion Sequential Compression Device Multi 3 ( ) - Manual (Page 10)

PresSsion ® Gradient Sequential - Multi 3 & Multi 6
O OP PE ER RA AT TIIO ON N
1. Place the unit on a firm and level surface.
2. Plug the power cord (female end) into the power cord receptacle. This is
located on the left side of Multi 6, and on the front of the Multi 3.
3. Plug the other end of the power cord (male end) into a grounded, electrical
outlet.
NOTE:
The pump operates best at room temperature. If the unit has been
stored below normal temperature, allow it to warm to room temperature for
proper operation.
4. Connect the air supply hose to the air supply connection. The connection is
located on the left side of the Multi 6, and on the front of the Multi 3.
5. When using only one garment, seal the upper row of holes (3 on the front of
the Multi 3, and 6 on the left side of the Multi 6) with the blanking plug
provided.
6. Connect the air supply hoses into the fittings on the garment.
7