Iii. your travel scooter, Figure 7. battery pack, Charger port – Activeforever Pride Go Go Elite Traveller Plus Electric Scooter User Manual

Page 20: Main circuit breaker (reset button), Battery pack, Battery pack handle, Battery pack fuse, Figure 8. 3-amp tiller console fuse

Advertising
background image

20

Main Circuit Breaker (Reset Button)

When the voltage in your Travel Scooter’s batteries becomes low or the Travel Scooter is heavily strained

because of excessive loads or steep inclines, the main circuit breaker may trip to protect the motor and

electronics from damage.

The main circuit breaker reset button pops out when the breaker trips.

When the breaker trips, the entire electrical system of your Travel Scooter shuts down.

Allow a minute or two for your Travel Scooter’s electronics to “rest.”

Push in the reset button to reset the main circuit breaker.

If the main circuit breaker trips frequently, you may need to charge your batteries more often. You may

also need to have your authorized Pride Provider perform a load test on your Travel Scooter’s batteries.

If the main circuit breaker trips repeatedly, see your authorized Pride Provider for service.

TILLER CONSOLE FUSE

The fuse located under the battery pack protects the

tiller console electronics. See figure 8. In the event

any component of the tiller console is not respond-

ing, check this fuse. See VIII. “Basic Troubleshoot-

ing” for fuse replacement instructions.

I I I . Y O U R T R A V E L S C O O T E R

Motor/Transaxle Assembly

The motor/transaxle assembly is an electrome-

chanical unit that converts electrical energy from

your Travel Scooter’s batteries into the con-

trolled mechanical energy that drives the Travel

Scooter’s wheels.

BATTERY PACK

Your Travel Scooter is equipped with an inno-

vative, easy to remove battery pack. A handle

on the top of the battery pack makes it easy to

lift the pack off of the Travel Scooter with one

hand. The battery pack contains two batteries

(standard 12 Ah or optional 17 Ah), the char-

ger power cord receptacle, the main circuit

breaker (reset button), and the battery pack

fuse. See figure 7.

Charger Port

The 3-pin end of the charger power cord plugs

into this port.

Figure 8. 3-Amp Tiller Console Fuse

Figure 7. Battery Pack

CHARGER PORT

MAIN CIRCUIT BREAKER
(RESET BUTTON)

BATTERY
PACK

BATTERY PACK HANDLE

BATTERY PACK FUSE

Advertising