Iv. batteries and charging, Figure 15. battery replacement (12 ah pack shown) – Activeforever Pride Go Go Elite Traveller Plus Electric Scooter User Manual

Page 25

Advertising
background image

25

I V . B A T T E R I E S A N D C H A R G I N G

How do I change a battery in my Travel Scooter?

MANDATORY! Battery posts, terminals, and related accessories contain lead and

lead compounds. Wear goggles and gloves when handling batteries and wash

hands after handling.

WARNING! Always use two batteries of the exact same type, chemistry, and amp-

hour (Ah) capacity. Refer to the specifications table in this manual and in the

manual supplied with the battery charger for recommended type and capacities.

WARNING! Do not mix old and new batteries. Always replace both batteries at

the same time.

WARNING! Contact your Pride Provider if you have any questions regarding the

batteries in your Travel Scooter.

WARNING! Do not replace the batteries while the Travel Scooter is occupied.

WARNING! The batteries on your Travel Scooter should only be serviced or

replaced by an authorized Pride Provider or a qualified technician.

1. Remove the battery pack from the Travel

Scooter.

2. Carefully turn the pack upside down.

3. Remove the eight (8) screws from the perim-

eter of the battery pack.

4. Carefully turn the pack right side up and

remove the lid.

5. Disconnect the black (-) and red (+) battery

cables from the battery terminals of each bat-

tery. See figure 15.

6. Remove the old batteries.

7. Place a new batteries in the battery pack.

8. Connect the red battery cable to the positive

(+) battery terminal of each battery.

9. Connect the black battery cable to the nega-

tive (-) battery terminal of each battery.

10. Position the lid back onto the battery pack

ensuring all wires are inside the pack so they

don’t become pinched.

11. Carefully turn the pack upside down.

12. Reinstall all screws and tighten.

Figure 15. Battery Replacement (12 Ah Pack Shown)

BATTERY TERMINALS

BATTERY CABLES

NOTE: 17 Ah batteries require the removal of a nut and bolt when disconnecting the battery cable from

the battery terminal.

NOTE: If you encounter a damaged or cracked battery, immediately enclose it in a plastic bag and

contact your local waste disposal agency or authorized Pride Provider for instructions on disposal and

battery recycling, which is our recommended course of action.

Advertising