00825 - inst08 pg2.pdf, Install batteries – AcuRite 00825 Weather Station User Manual

Page 2

Advertising
background image

Batteries must be installed into all three of the wireless sensors BEFORE

installing batteries into the main display unit. Use only fresh or new

batteries in all cases, and install correctly according to the polarity

( - & + ) symbols marked on the batteries and in the battery

compartments. We suggest using lithium batteries for better cold

weather performance. Do not mix old and new batteries.

INSTALL BATTERIES:

1. Remove larger

rounded solar shield.

2. Remove the battery

compartment cover.

3. Install 2 “AA”

batteries into the

battery compartment.

4. Replace the

compartment cover

and replace the solar

shield.

SECTION 2 • SETUP

Install Batteries

To allow for more than one weather station and wireless sensor

network to be used in close proximity, the main unit and both wireless

sensors have a small switch labeled “A B C” in the battery

compartments. These switches are all factory preset into the same

position (either A, B, or C). This switch selects one of 3 wireless modes

to use, and all 3 switches in all 3 components MUST be set in matching

positions (either A, B, or C) for wireless communication to take place

successfully. See page 11 for more details.

A/B/C Wireless ID Selection

Wireless Temperature & Humidity Sensor

- 3 -

- 2 -

SECTION 1 • OVERVIEW OF FEATURES

Outdoor

Temperature

Future

Weather

Forecast

Barometric

Pressure

Barometric

Pressure

History

Outdoor

Humidity

Wind Direction

Wind Speed

Wind Gust

Seasonal

(wind chill)

Indoor

Temperature

Indoor

Humidity

Atomic

Clock

Month

& Date

Wireless Temperature

& Humidity Sensor

Wireless

Wind Sensor

Sends temperature and

humidity information to

the main unit

via a 433 mhz wireless

signal. This sensor

should be mounted

out of direct sunlight to

ensure accurate readings.

Powered by 2 “AA”

batteries.

Sends wind speed and

direction to main unit

via a 433 mhz wireless

signal. This sensor

should be mounted

high enough to accurately

record and transmit wind

information. Powered by 2

“AA” batteries.

N

E

W

NW

SW

NE

SE

S

AM

PM

TIME ZONE

DST

FUTURE FORECAST

OUTDOOR

WIND GUST

WIND SPEED

INDOOR

WIND CHILL

PST MST CST EST

OFF ON

InHg

HISTORY

HR.

PRESSURE

HPa

mph

kph

knots

mph

kph

knots

MIN

MAX

MIN

MAX

MIN

MAX

REMOVE

BATTERY

DOOR

INSTALL

BATTERIES

Advertising