AcuRite 00825 Weather Station - Manual (Page 3)

- 5 - - 4 -
INSTALL BATTERIES:
1. Unscrew and
remove bottom case
section.
2. Remove the battery
compartment cover..
3. Install 2 “AA”
batteries into the
battery compartment.
4. Replace the battery
compartment cover
and replace and
rotate the bottom
cone section until it is
securely tightened.
Wireless Wind Sensor
INSTALL BATTERIES:
1. Remove the battery
compartment cover.
3. Install 3 “AA”
batteries into the
battery compartment.
4. Replace the battery
compartment cover.
Main Unit
REMOVE
SLIDING BATTERY
COMPARTMENT COVER
UNSCREW BOTTOM CASING
INSTALL
BATTERY
INSTALL
BATTERY
REMOVE
BATTERY
COMPARTMENT
COVER
INSTALL
3 ” AA”
BATTERIES
SET
+
_
MIN
MAX
SCALE
HISTORY
After batteries are installed in both wireless sensors and the main unit is
powered up, the main unit will search for the wireless sensor signals.
After the sensors signals are received, the main unit will search for the
atomic clock signal. After the atomic clock signal is received, the time
and date will be maintained automatically. This may take up to 24 hours
and may not occur at all depending on your geographical location and
your physical surroundings. See “troubleshooting” for atomic clock tips.
You may “force” the unit to search for the atomic clock at any time by
pressing and holding the “-” button on the back of the main unit for 3
seconds.
SECTION 2 • SETUP
Main Unit Startup
It is recommended that the time and date be manually set initially to
ensure that they are accurate until the atomic clock signal is captured.
To enter into SET MODE, press and hold the “SET” button for 3 seconds.
Use the “-” and “+” buttons to adjust the selected preference, press the
“SET” button again to confirm the adjustment and move on to the next
preference.
The main unit will automatically exit out of SET MODE after a 10 second
period of inactivity.
SET MODE in this order:
1. Time zone (Pacific, Mountain, Central, Eastern)
2. Daylight Saving Time (DST on or off)
3. Time (hour first, then minutes)
4. Year
5. Month
6. Date
Scale Setup
You may choose to display readings in U.S. or Metric scales (example ºF
or ºC). To change the scale preferences, enter into scale set mode.
To enter into SCALE MODE, press the “SCALE” button.
Use the “-” and “+” buttons to adjust the selected preference, press the
“SCALE” button again to confirm the adjustment and move on to the next
preference.
Time & Date Setup