Acura 2013 TSX Sport Wagon - Manual (Page 242)

241
uu Maintenance Under the Hood u Changing the Engine Oil and Oil Filter
6. Check that the filter gasket is not stuck to
the engine contact surface.
u If it is stuck, you must detach it.
7. Wipe away dirt and dust adhering to the
contact surface of the engine block, and
install a new oil filter.
8. Put a new washer on the drain bolt, then
reinstall the drain bolt.
u Tightening torque: 29 lbf∙ft
(39 N∙m, 4.0 kgf∙m)
9. Pour the recommended engine oil
into the engine.
u Engine oil change capacity
(including filter):
4.2 US qt (4.0 L)
10. Reinstall the engine oil fill cap securely and
start the engine.
11. Run the engine for a few minutes, and
then check that there is no leak from the
drain bolt or oil filter.
12. Stop the engine, wait for three
minutes, and then check the oil level on
the dipstick.
u If necessary, add more engine oil.
1 Changing the Engine Oil and Oil Filter
You will need a special wrench to replace the oil
filter. You can buy this wrench from a dealer.
When installing the new oil filter follow the
instructions supplied with the oil filter.
Reinstall the engine oil fill cap. Start the engine.
The low oil pressure indicator should go off within
five seconds. If it does not, turn off the engine, and
check your work.
Oil Filter
13 ACURA TSX 5D-31TL76200.book 241 ページ ２０１２年７月２７日 金曜日 午前９時４２分
QRG
Index
2013 TSX Sport Wagon
Main
tenan
ce
TOC