Acura 2013 TSX Sport Wagon - Manual (Page 280)

Continued 279
uu Temporarily Repairing a Flat Tire u
4. Plug in the compressor to the accessory
power socket. Be careful not to pinch the
cord in a door or window.
u Do not plug any other electric devices
into other accessory power sockets.
5. Start the engine.
u Keep the engine running while injecting
sealant and air.
2 Carbon Monoxide Gas P. 61
6. Turn the selector switch to
.
7. Press the inflator switch to turn on the kit.
u The compressor starts injecting sealant
and air into the tire.
8. When the sealant injection is complete
continue to add air.
9. After the air pressure reaches 33 psi
u To check the pressure, occasionally turn
off the compressor and read the gauge.
1 Injecting Sealant and Air
Until the sealant injection is complete, the pressure
shown on the pressure gauge will appear higher than
actual. After the sealant injection is complete the
pressure will drop and then begin to rise again as the
tire is inflated with air. This is normal. To accurately
measure the air pressure using the gauge, turn the air
compressor off only after the sealant injection is
complete.
If the required air pressure is not reached within 10
minutes, the tire may be too severely damaged for
the kit to provide the necessary seal and your vehicle
will need to be towed.
See an Acura dealer for a replacement sealant bottle
and proper disposal of an empty bottle.
3 WARNING
Running the engine with the vehicle in an
enclosed or even partly enclosed area can
cause a rapid build-up of toxic carbon
monoxide.
Breathing this colorless, odorless gas can
cause unconsciousness and even death.
Only run the engine to power the air
compressor with the vehicle outdoors.
SEALANT/AIR side
Pressure Gauge
ON
OFF
13 ACURA TSX 5D-31TL76200.book 279 ページ ２０１２年７月２７日 金曜日 午前９時４２分
QRG
Index
2013 TSX Sport Wagon
Han
d
lin
g the U
n
expected
TOC
SEALANT/AIR
(230 kPa), turn off the kit.