Binatone TP-3050 - Manual (Page 7)

7
ENGLISH
BEFORE USING THE
APPLIANCE
Read this operating manual which tells you
how to operate the appliance.
Before the first use of the appliance, boil
and pour out water several times.
OPERATING MANUAL
1. Place the appliance on a dry horizontal sur-
face.
2. Open the lid (3), by turning it to the right.
When the mark «opened lock» on the lid coin-
cides with the arrow on the casing (1), remove
the lid.
3. Fill the thermopot with water; in doing so be
careful so that water does not splash onto the appliance casing
and its electrical parts.
Attention: Do not pour water in the thermopot from the side
where the control panel (5) is located. If water
penetrates inside the panel, this could result in
failures in the appliance operation.
4. Make sure that the water level does not exceed the maximum mark
on the water level indicator (9). Do not turn on the thermopot when
empty. Amount of water minimum required should not be lower
then the lowest mark on the water level scale.
Note: If the water level is lower than the small pipe on the
heating element, the protection system preventing
waterless operation activates and the appliance is
switched off.
5. Place the lid (3) on the casing (1) so that the arrows on the casing
and the mark «opened lock» on the lid concide. Close the lid (3),
turning it to the left. The mark «closed lock» on the lid (3) and the
arrow on the casing (1) should be coinside.
6. Connect the removable power cable (11) and insert the plug into
a power supply with voltage that should comply with the data on
the appliance.
Attention: Never connect the power cable if hands are wet.
7. When first connecting to a power supply, the indicator “Boil” will
light up and the thermopot will immediately start boiling.
8. Immediately after boiling the thermopot will enter the water tem-
perature maintenance mode. Indicator “Keep warm” will light up.
9. To pour water out of the thermopot, press the button “Unlock”
and release the preset locking mode. The symbol “Unlock” will
show that the locking mode is released. Place a cup under the
water supply port (6) and press the button “Dispense”. Re-