Binatone TP-3050 - Manual (Page 8)

8
lease the button when the cup is full. Ten seconds later the
water dispense mode will be set and the indicator “Unlock” will
go out.
10. For water re-boiling, press the button “Boil”.
11.Before re-using the appliance, empty the water out - as water can
change its color and odor, and yellow spots could appear on the
heating element.
Attention: To fully pour water out from the bulb, do not use
button “Dispense”. Pour out water directly from the
internal bulb.
Use of the decorative replaceable panels
1. There are 2 additional replaceable panels for this device. To change
the design of the device carefully peel the existing panel by
its corner making sure that it has not torn. Then remove the new
panel from the paper base and paste it place of the panel you have
removed. Make sure that the glue of the panel has not dried up, then
you could use it again. The panel should be stored in the following
way; the new panel should be pasted onto a special place which
precisely repeats the form of the panel. Remove the protective
film and smooth the panel for the best fixing.
Attention: Please note that the paper base and a protective
film could be used next time, if they are kept smooth
and not rumpled.
2. Pay attention, that the replaceable panels have a limited life and
with correct storage, use and careful application you can re-use them
2-3 times.
MAINTENANCE AND
CLEANING
1. Before cleaning or storing, disconnect the
appliance from the power supply and wait
until the appliance is completely cooled.
2. To avoid electrical injuries, do not place the casing
(1) and power cable (11) in water. The parts of
the appliance as well as the internal bulb (2) can
be cleaned by using a damp lint free cloth.
3. Store the appliance only when completely dry.
HELPFUL HINTS
In areas with high water hardness, scale must
be regularly removed from the appliance to keep it
in good operating condition, since an excessive
scale in the appliance could result in the appliance
maloperation or failure. Frequency of de-scaling
depends on the tap water hardness in your region
and how often you use your thermopot. If water in
your house is hard, we recommend filtering it - this will decrease
the amount of deposited scale substantially.