Garmin GPSMAP 185 Sounder - Manual (Page 94)

84
To flush mount the GPSMAP 185 Sounder:
1. Remove the four M5 screws from the back of the unit and remove the mounting
bracket .
2. Using the mounting template provided in the box, determine the location where you
want to mount the unit and tape the template in place.
3. Using a hammer and center punch, mark the centers of the relief hole and mounting
screw holes.
4. Using a drill and 2.75” hole saw, cut the center relief hole from the panel. Drill the four
0.25” screw holes, using a 1/4” drill bit.
5. From the front, place the GPSMAP 180 into the relief hole until the unit rests flush
against the mounting surface.
6. Secure the unit to the mounting surface using M5 screws. Note: For thick mounting sur-
faces, insert the M5 screws directly thru the four drilled holes (figure 1). For thin panels,
place the mounting bracket on the back side of the panel for more support (figure 2).
7. Attatch the power/data/transducer cable and antenna connectors.
SECTION
A
APPENDIX
Installation
Figure 1 Figure 2
Mounting template provided in box
Mounting Template