Garmin GPSMAP 185 Sounder - Manual (Page 99)

radius for the proximity waypoint indicated.
Proximity List Full—You have used all nine
proximity waypoints.
Proximity Overlaps Another Prox Wpt—The
alarm radius specified overlaps the area specified
for another proximity waypoint. (See section 10
for more information on proximity overlaps.)
RAM has Failed—The random access memory
has failed and the unit is not operable. Take
your unit to an authorized GARMIN service cen-
ter for repairs.
ROM has Failed—The unit’s permanent memory
has failed and the unit is not operable. Take
your unit to an authorized GARMIN service cen-
ter for repairs.
Received Invalid Waypoint—A waypoint was
received during upload transfer that has an
invalid identifier.
Receiver has Failed—A failure in receiver hard-
ware has been detected. If this message persists,
do not use the unit and take it to an authorized
dealer for repair.
Route Already Exists—The route number you
are trying to copy to is already used.
Route Does Not Exist—The route number you
are trying to use or copy is not defined.
Route is Full—You have attempted to add more
than 30 waypoints to a route.
Route Memory is Full—You have attempted to
create more than 20 routes.
Route Waypoint was Deleted—A route waypoint
entered does not exist in the database and has
been deleted from the route.
RTCM Input has Failed—DGPS data being
received has been lost. You are no longer receiv-
ing the beacon signal.
Searching the Sky—The GPSMAP 185 Sounder
is searching the sky for almanac data.
Shallow Water Alarm—The depth is equal to or
less than the set alarm depth.
Sonar ASIC has Failed—The unit’s internal mon-
itoring system indicates a malfunction. Send in
for service as soon as possible.
Stored Data was Lost—All waypoints, routes and
almanac data has been lost due to internal bat-
tery failure.
There is No RTCM Input—The beacon receiver
is not properly connected or baud rates do not
match.
Timer Has Expired—The countdown timer has
expired.
Track Memory is Full—The track memory is full
and no additional track plot will be recorded
until the track memory has been cleared or set to
wrap mode.
Transducer-Sounder Turned Off—The transduc-
er signal is not reaching the unit because of a
loose connector, bad wiring, or transducer mal-
function.
Wpt Already Exists—The waypoint name you’ve
entered already exists in memory.
Waypoint Memory is Full—You have used all
250 waypoints in the GPSMAP 185 Sounder sys-
tem.
89
SECTION
C
APPENDIX
Messages