Garmin NavTalk - Manual (Page 68)

5.14 Setting Up Dial String Codes for
Automated Phone Services
You can program the NavTalk to dial DTMF
Tones for a wide variety of automated phone
system services. You can program calling card
PIN’s, link phone numbers from the PhoneBook
page, pause in a dial string, stop dialing until
you press send again after listening to prompts
at the call destination, and to transmit your GPS
position via DTMF tones.
NOTE: When you add a Dial String Code to a number
string you must use the
UP or DOWN Rocker Pad Arrows
to enter the code. These keys display only the code letters
and numerals used to create a dial string with DTMF
tones.
To create a DTMF Dialing String:
Dial String codes are used to tell the NavTalk
how and when to send DTMF tones to a call’s
destination and can allow you access to any ser-
vice that employs DTMF tones. To create a dial
string for your DTMF application use the follow-
ing codes to create appropriate pauses, stops and
links in the dial string. Shown below is a chart
listing DTMF codes and their function.
Pauses Dialing for Insert where dialing must
5 seconds. pause for recorded
messages or switching
functions before resuming.
Stops dialing to wait for Insert when dialing time
SEND keystroke. delays are unpredictable.
DTMF dialing string prefix Place at beginning of a dial
string you want to be sent as
DTMF tones.
Stops to display PhoneBk Insert when you want to call
and links the Highlighted a number listed in your
number as the SEND key PhoneBk using a Calling
is pressed. Card, etc. for a prefix.
Transmits your GPS Inserted after a dial string
Position. to another NavTalk unit.
The code for your Calling Automatically enters your
Card PIN as entered in PIN when making a call.
Phone Setup Directory.
Queries another NavTalk Insert at the end of a dialing
for its GPS position. string to another NavTalk
Unit for position reporting.
Star and Pound Keys. Used for standard DTMF tones
56
Cell Phone
Reference
SECTION 5
Calling Card “C” code
Sprint Access Number
“S” code, Stops
dialing to allow for
phone number entry.
A “P” code entered
into the dial string causes a
5 second pause before
completing the dial string
P
S
D
L
T
C
Q
* #
Code Function When To Use
NavTlkOM.qxd 2/1/00 2:46 PM Page 66