Garmin G1000 Quest Kodiak - Manual (Page 467)

190-00590-02 Rev. A Garmin G1000 Pilot’s Guide for the Quest Kodiak 100
SY
STEM
O
VER
VIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO P
ANEL
& CNS
FLIGHT
MANA
GEMENT
HAZARD
AV
OID
ANCE
AFCS
ADDITIONAL
FEA
TURES
APPENDICES
INDEX
455
APPENDIX b
3) Turn the system ON. A prompt similar to the following is displayed.
Figure B-3 Standby Navigation Database Prompt
4) Press the YES Softkey, to start the update.
5) After the navigation database files are copied to the bottom SD card. A prompt similar to the following is
displayed.
Figure B-4 Active Navigation Database Prompt
6) Press the YES Softkey to manually update the active navigation database, or press the NO Softkey to allow the
system to automatically update the active navigation database as applicable per database effectivity.
7) After the update, the display starts in normal mode.
8) Repeat steps 1-7 for each PFD and the MFD, if updating manually.
9) Verify the effectivity of the active navigation database in each PFD and the MFD on the AUX-System Status
Page.
NOTE: The system compares the active databases on each PFD and the MFD, and displays a system alert
message ‘DB Mismatch’ if they are not identical. Similarly, if the standby databases on each PFD and the
MFD are not identical, the system will display a ‘DB Mismatch’ alert for the standby navigation databases.
Garmin recommends enabling the automatic database synchronization feature to protect against database
mismatches.
GARMIN DATAbASES
The following databases are stored on Supplemental Data Cards provided by Garmin:
• Expanded basemap
• Terrain
• Airport terrain
• Obstacle
• SafeTaxi
• FliteCharts
• Airport Directory
(AOPA)