Garmin GNC 300XL TSO - Manual (Page 63)

Renaming a user waypoint.
User waypoint list showing the current active-to
waypoint and a proximity waypoint.
SECTION
3
WPT KEY
User Waypoint
List
The third page available from the GNC 300XL’s W key is the user waypoint
list, which can be used to quickly scan, review, rename or delete user waypoints.
To display the user waypoint list:
1. Press
W
and use
O
to display the user waypoint list.
2. To scroll through the list, rotate K .
The total number of user waypoints is displayed at the top of the page, with the
individual user waypoints listed two at a time in alphabetical order below. The arrow
prompt, located at the top left of the page, will indicate which direction to scroll to
view additional waypoints. The status of each waypoint will be displayed to the right
of the identifier when it is the active-to waypoint, part of an active or stored route or
a proximity waypoint. To edit, rename or delete waypoints, the cursor must highlight
the desired waypoint.
To highlight a waypoint:
1. Press C twice and use O to highlight the desired waypoint.
To edit a highlighted waypoint’s position:
1. Press
E
to obtain the waypoint position page. Edit the waypoint position as described on
page 49. (Note: The active-to waypoint cannot be edited.)
To delete a waypoint from the list:
1. Highlight the desired waypoint and press \ . Press E to confirm the deletion.
To rename a waypoint from the list:
1. Highlight the desired waypoint. Use K and O to enter a new
identifier for the waypoint.
2. Press E on the confirmation page to change the name, or press \ to cancel. 53
300xl manual 1/25/99 2:35 PM Page 53