Garmin GPS 155XL TSO - Manual (Page 127)

Route wpt deleted - One or more route waypoints were deleted
while receiving data from the optional PC
Interface Kit.
Route wpt locked - At least one route waypoint is locked because
the waypoint has been removed from the
Jeppesen NavData®, the data card is missing,
or the data card has failed.
Route wpt moved - One or more route waypoints were moved at
least 0.33 arc minutes due to a database change.
RTCM input fail - The DGPS data signal was being received but
has now been lost. Check wiring.
SID deleted - The SID was deleted from the route because of
insufficient space in the route.
STAR deleted - The STAR was deleted from the route because
of insufficient space in the route.
Searching the sky - The GPS 155XL is in the search-the-sky mode.
Allow the unit to complete data collection
before turning it off.
Select auto seq mode - The GPS SEQ switch should be set to the ‘Auto’
position to continue navigation.
Set course to ____° - The CDI/HSI should be set to the specified
course.
Start altitude chng - The altitude change entered on the VNAV
Planning page is about to begin.
Steep turn ahead - This message appears approximately 90 seconds
prior to a turn that requires a bank angle in excess
of 25 degrees in order to stay on course. Turn
anticipation will not be provided for the turn.
Stored data lost - Stored user data, including waypoints, routes
and satellite orbital data have been lost due to a
low memory battery or inadvertent master reset.
SUA ahead < 10 min - The projected course and current speed will take
you inside an SUA within the next 10 minutes.
SUA near & ahead - Your position is within two nautical miles of an
SUA and your current course will take you
inside.
Timer expired - The approach timer has expired.
User data RX started - Data receive operations have started.
Usr data TX complete - Data transmit operations are complete.
VNAV cancelled
- The VNAV function has been cancelled due to a
change in the active route.
WGS 84 datum selectd-The system map datum was changed to WGS
84 because the selected map datum has been
removed from the NavData card, the data card
is missing, or the data card has failed.
Wpt comment locked - At least one waypoint comment is locked
because the waypoint has been removed from
the Jeppesen NavData®, the data card is miss-
ing, or the data card has failed.
Wpt exists _____ - You have entered a waypoint name on the
AutoStore™ page or user waypoint catalog page
that already exists in memory. Enter a waypoint
name that does not exist.
Wpt memory full - The waypoint memory is full. You should delete
unused waypoints to make room for new way-
points.
117
APPENDIX
D
MESSAGES &
ABBREVIATIONS
155xlb manual 1/12/99 4:06 PM Page 117