Garmin GPS 155XL TSO - Manual (Page 91)

Selecting and Loading an Approach
When an arrival airport is selected with the direct-to key (or created and activated in
a route to the arrival airport), the approaches for your arrival airport become available
through the approach select page, which can be viewed by pressing
R and rotating
the outer knob. Remember that an airport must be the last waypoint in a route to select
an approach.
To select an approach:
1. Select the destination airport using the
D
key, or create and activate a route
to the destination airport (see Section 4).
2. Press
R
and rotate
O
to display the approach select page.
3. Rotate K (or O with the cursor active) to display the desired approach procedure.
4. Press
C
twice (if necessary) and rotate
O
until the desired approach is highlighted.
5. Press
E
to select the approach.
If an approach procedure has more than one Initial Approach Fix (IAF), you’ll need
to select the desired IAF identifier for your approach.
To select an IAF:
1. Rotate
O
until the desired IAF is highlighted.
2. Press E .
Once the IAF is selected, the approach waypoints will be inserted into Route 0,
replacing the destination airport, and the active route page will be displayed. To review
the active route, rotate the
K knob. The scrolling arrow prompt will indicate which
direction to scroll to view additional waypoints, while the ‘if’, ‘ff’ and ‘mp’ designators
will indicate the IAF, FAF and MAP respectively.
81
SECTION
5
APPROACH NAV
Selecting
Approaches
Once the approach is loaded, the active route page
will appear.
Select the Initial Approach Fix.
155xlb manual 1/12/99 4:06 PM Page 81