Garmin GPS 150 - Manual (Page 65)

If you turn automatic leg sequencing off, you must manually advance the route
you are navigating to the next waypoint.
To manually sequence the active route legs:
1. Press
R
and rotate
O
until the Active Route page is displayed.
2. Rotate
K
until the next desired destination waypoint is displayed.
3. Press
C
and rotate
O
to highlight the next destination waypoint.
4. Press
D
. Press
E
to confirm the waypoint.
This will change the leg of the active route, making the selected waypoint the
‘active to’ waypoint.
Similarly, if you turn automatic leg selection off, you must manually select the
starting leg.
To manually select the active (starting leg):
1. Activate the desired route as described in Section 3, page 43.
2. Rotate
K
until the beginning waypoint of the desired leg is displayed.
3. Press
C
and rotate
O
until the beginning waypoint of the desired leg is highlighted.
4. Press
D
. Press
E
to confirm the waypoint.
An on-route direct-to will provide course guidance to the selected waypoint and
then provide guidance to navigate the remaining legs of the route (providing automatic
leg sequencing is on).
55
REFERENCE
Sequencing and Selecting
Route Legs
Section
5
Active Route page
150man rev E 7/24/98 3:10 PM Page 55