Garmin GPS 150 - Manual (Page 82)

Checklist is full - The selected checklist is full. No new items can be added
until existing items are deleted.
Collecting data - The GPS 150 is collecting orbital data while searching the
sky. The antenna should have a good view of the sky and the
GPS 150 should be allowed to finish data collection before
turning the unit off.
Comment memory full - The waypoint comment memory is full. You must delete
existing waypoint comments before adding new ones.
Data card failed - The GPS 150 has detected a problem with the data card. The
data is not usable and the card should be returned to an
authorized GARMIN service center.
Data card write fail - The user data card failed to program.
Degraded accuracy - The accuracy of the GPS 150 position is degraded beyond
500 meters due to satellite geometry or data quality.
Additional cross checking should be performed by the user
to verify the integrity of the GPS 150 position.
Do not use for nav - The GPS 150 is in the simulator mode and must not be used
for actual navigation.
Final altitude alert - The suggested altitude is within 1000 feet of the final alti-
tude entered on the VNAV Planning page.
Fuel/Air input fail - The fuel and/or air data input is not available to the GPS
150. Check the I/O settings or fuel/air data system.
Inside SUA - The unit has entered a Special Use Airspace.
Invald CPA wpt _____ - The closest point of approach cannot be created from the way-
point entered on the CPA Page. This occurs when the computed
point does not fall on one of the route legs, or when a unique
waypoint name for the closest point of approach cannot be found.
Invalid copy route - A non-empty route was selected for a copy operation. A route
must be empty before another route can be copied to it.
Invalid CPA route - The selected route contains less than two waypoints and can-
not be used for CPA operations. 72
APPENDIX C
GPS 150 Messages
150man rev E 7/24/98 3:11 PM Page 72