Garmin SL60 - Manual (Page 20)

Entering a
Seed
Position
After the start up tests, you will always have the
choice of entering a Seed Position. The Seed
Position is a starting reference point so the GPS
receiver knows what satellites it is looking for. If a
Seed Position has been previously entered, you do
not need to select a new Present Position or a
Reference Waypoint. If you do not make any
selections, the Apollo SL50/60 will automatically
progress into the Navigation function.
1. The previous Seed Position will display with the
choice of SEL/ENT for a few seconds. If you don’t
do anything, the Apollo SL50/60 will continue
normally. You can also press ENT to accept the
current position, though this is not required.
0.3nm 277
0 To SLE
SEL/ENT
2. Press SEL to change the Seed Position.
3. The current Reference Position will be displayed
and the Chg? prompt will flash.
44
054.46N 122059.69W Ref: Chg?
Press ENT to change the Reference Waypoint or
turn the Large knob to change to Lat/Lon
Reference Position. Use the appropriate following
description: Change Reference Waypoint or Change
Lat/Lon Reference Position.
Change Reference Waypoint
1. After pressing ENT, the first character of the
Reference Waypoint name will flash. You can
change the waypoint type by turning the Large
knob ccw one click and the turning the Small
knob.
aPDX c PORTLAND OR USA
10
Getting Started the First Time
SEL
ENT
ENT