Dell Latitude 120L User Manual

Page 19

Advertising
background image

Quick Reference Guide

19

b

Press and hold the <Fn> key while starting the computer.

NOTE:

If you see a message stating that no diagnostics utility partition has been found, run the Dell

Diagnostics from the

Drivers and Utilities CD.

The computer runs the Pre-boot System Assessment, a series of initial tests of your system board,
keyboard, hard drive, and display.

During the assessment, answer any questions that appear.

If a failure is detected, the computer stops and beeps. To stop the assessment and restart the
computer, press <Esc>; to continue to the next test, press <y>; to retest the component that
failed, press <r>.

If failures are detected during the Pre-boot System Assessment, write down the error code(s) and
contact Dell (see "Contacting Dell" in your User’s Guide).

If the Pre-boot System Assessment completes successfully, you receive the message

Booting Dell

Diagnostic Utility Partition. Press any key to continue

.

5 Press any key to start the Dell Diagnostics from the diagnostics utility partition on your hard drive.

Starting the Dell Diagnostics From the Drivers and Utilities CD

1 Insert the Drivers and Utilities CD.
2 Shut down and restart the computer.

When the DELL logo appears, press <F12> immediately.

If you wait too long and the Windows logo appears, continue to wait until you see the Windows
desktop. Then shut down your computer and try again.

NOTE:

The next steps change the boot sequence for one time only. On the next start-up, the computer boots

according to the devices specified in the system setup program.

3 When the boot device list appears, highlight CD/DVD/CD-RW Drive and press <Enter>.
4 Select the Boot from CD-ROM option from the menu that appears and press <Enter>.
5 Type

1

to start the menu and press <Enter> to proceed.

6 Select Run the 32 Bit Dell Diagnostics from the numbered list. If multiple versions are listed, select

the version appropriate for your computer.

7 When the Dell Diagnostics Main Menu appears, select the test you want to run.

Advertising